JVC KW-V40BT Manual De Instrucciones página 51

CONNECTION/INSTALLATION CONNECTION/INSTALLATION
Connection
Connecting wires to terminals
See pag 52.
USB terminal: See
page 52.
Connect the antenna
cord to the antenna
terminal.
1
White ª / White with black stripe · : To front speaker (left)
Gray ª / Gray with black stripe · : To front speaker (right)
Green ª / Green with black stripe · : To rear speaker (left)
Purple ª / Purple with black stripe · : To rear speaker (right)
Blue (Power antenna wire)
Blue with white stripe (Remote output wire)
Light blue with yellow stripe (Steering remote control wire)
Orange with white stripe (Dimmer control wire)
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
REVERSE
See page 53.* 1
GEAR
SIGNAL
PARKING
BRAKE
10 A fuse
Connect SiriusXM Connect Vehicle Tuner
(commercially available).*
*
3
(POWER ANTENNA)
(REMOTE OUTPUT)
(STEERING WHEEL REMOTE)
(ILLUMI)
(ACC)
(BATT)
(GND)
Connect to the vehicle's reverse lamp harness when
Purple with white stripe
using the optional rear view camera.
(Reverse sensor wire)
Light green
(Parking sensor wire)
3
2 (Page 52)
* Only for KW-V40BT/KW-V20BT/KW-V200BT.
1
* 2 Only for KW-V40BT Region 1/KW-V20BT Region 1/KW-V200BT/
KW-V10 Region 1/KW-V100.
* 3 If no connections are made, do not let the cable come out from
the tab.
To automatic antenna if any (250 mA max.)
To the remote lead of other equipment (200 mA max.)
To the OE remote adapter matching your car
To car light control switch
To car chassis
Connect to the vehicle's parking
brake detection switch harness.
• For best safety, be sure to
connect the parking sensor.
Ignition key switch
Fuse box
Battery
ENGLISH 51