Notice/Caution On Using Bluetooth Device; Specifications - JVC KW-V40BT Manual De Instrucciones

Ocultar thumbs Ver también para KW-V40BT:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

REFERENCES
REFERENCES
The unit does not make pairing with the
Bluetooth device.
• For devices compatible with Bluetooth 2.1:
Register the device using a PIN code. (Page 31)
• For devices compatible with Bluetooth 2.0:
Enter the same PIN code for both the unit and
target device. If the PIN code of the device is not
indicated on its instructions, try "0000" or "1234."
Echo or noise occurs.
• Adjust the microphone unit position.
• Make sure that the NR/EC (Noise reduction/Echo
cancel) function is activated. Adjust the echo
volume or noise reduction volume if necessary.
(Page 33)
The unit does not respond when you try to copy
the phone book to the unit.
• You may have tried to copy the same entries (as
stored) to the unit.
Notice/Caution on using Bluetooth
device
IC (Industry Canada) Notice
This device complies with Industry Canada licence-
exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and (2)
this device must accept any interference, including
interference that may cause undesired operation of
the device.
The term "IC: " before the certification/ registration
number only signifies that the Industry Canada
technical specification were met.
CAUTION
This equipment complies with FCC/IC radiation
exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency
(RF) Exposure Guidelines in Supplement C to OET65
and RSS-102 of the IC radio frequency (RF) Exposure
rules. This equipment has very low levels of RF
energy that it deemed to comply without maximum
permissive exposure evaluation (MPE). But it is
desirable that it should be installed and operated
keeping the radiator at least 20 cm or more away
from person's body (excluding extremities: hands,
wrists, feet and ankles).
Under Industry Canada regulations, this radio
transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than
that necessary for successful communication.
• Contains Transmitter Module
FCC ID : XQN-BTR60X
• Contains Transmitter Module
IC: 9688A-BTR601

Specifications

Monitor section
Picture Size (W x H)
KW-V40BT :
6.95 inches (diagonal) wide
156.6 mm x 81.6 mm (6-3/16" x
3-3/16")
KW-V20BT/KW-V200BT/KW-V10/KW-V100:
6.1 inches (diagonal) wide
136.2 mm x 72 mm (5-6/16" x
2-13/16")
Display System
Transparent TN LCD panel
Drive System
TFT active matrix system
Number of Pixels 1 152 000 (800H × 480V × RGB)
Effective Pixels
99.99%
Pixel Arrangement
RGB striped arrangement
Back Lighting
LED
DVD player section
D/A Converter
24 bit
Audio Decoder
Linear PCM/Dolby Digital/MP3/
WMA /WAV
Video Decoder
MPEG1/MPEG2/DivX /JPEG
Wow & Flutter
Below Measurable Limit
Frequency Response
96 kHz Sampling: 20 Hz – 22 000 Hz
48 kHz Sampling: 20 Hz – 22 000 Hz
44.1 kHz Sampling: 20 Hz – 20 000 Hz
Total Harmonic Distortion
0.010% (1 kHz)
ENGLISH
61

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Kw-v20btKw-v200btKw-v10Kw-v100

Tabla de contenido