Angelo Po 0G1FR3GD Manual De Uso página 54

ELECTRICAL CONNECTION (0G1FR3GD)
Important
The connection must be made by authorised,
skilled personnel, in accordance with the rele-
vant legal requirements, using appropriate
and specified materials. The appliance is sup-
plied with operating voltage 230V/1N 50Hz
(220V/1N 60Hz available on request).
Caution - warning
Before doing any work, cut off the mains elec-
tricity supply.
Connect the appliance to the mains electricity sup-
ply as follows.
1 - If not already present, install a circuit-breaker
(A) with overload cutout and differential safety
breaker close to the appliance.
2 - Open the hatch (B).
3 - Undo the screws (C) to remove the guard
(D).
4 - Undo the screws (E) to remove the lid (F).
5 - Move the box (G) forward until it reaches the
stop.
6 - Connect the circuit-breaker (A) to the terminal
board (H) of the appliance as shown in the dia-
gram and in the electrical system diagram at
IT
the back of the manual.
Use a cable with at least H05RN-F character-
GB
istics.
ELECTRICAL CONNECTION (1G1FR4GD)
DE
Important
FR
The connection must be made by author-
ised, skilled personnel, in accordance with
ES the relevant legal requirements, using ap-
propriate and specified materials. The appli-
ance is supplied with operating voltage 230V/
1N 50Hz (220V/1N 60Hz available on request).
Caution - warning
Before doing any work, cut off the mains elec-
tricity supply.
Connect the appliance to the mains electricity sup-
ply as follows.
1 - If not already present, install a circuit-breaker
(A) with overload cutout and differential safety
English
B
A
Important
When connecting, take care over the con-
nection of the neutral and earth wires; if
they are not connected correctly, the burn-
er does not light.
7 - Fit the lid (F) and secure it with the screws.
8 - Replace the guard (D).
9 - Close the door (B) when the operation is com-
plete.
B
A
breaker close to the appliance.
2 - Open the hatch (B).
- 22 -
D
E
G
IDM-39603313900.tif
C D C E
IDM-39603311900.tif
C
E
F
H
C