Checking Gas Pressure; Fault - Angelo Po 0G1FR3GD Manual De Uso

To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Open the hatch (A).
3 - Undo the screw (B) of the pressure connection.
4 - Connect the pressure gauge (C) to the pres-
sure test point.
5 - Turn the gas supply tap back on.
6 - Use the knob (D) to light the burner (see page
11)
7 - Perform a cooking cycle without food at the
maximum temperature then check that the
pressure reading complies with the values pro-
vided in the table at the back of the manual.
8 - Switch off the burner, turn off the gas supply tap
and disconnect the pressure gauge.
9 - Restore the initial conditions after completing
the operation.
The appliance has been tested before being put
into service.
The information provided below is intended to as-
IT IT
sist in the identification and correction of any anom-
alies and malfunctions which might occur during
GB GB
use.
The user can solve some of these problems him-
DE DE
self, but for others specific technical knowledge or
skill is required, and so they must only be carried
out by qualified staff with recognised experience
FR FR
acquired in the specific sector of operation.
ES
ES

Fault

Smell of gas.
The pilot light does not ignite.
English

CHECKING GAS PRESSURE

TROUBLESHOOTING
Occasional leak because flame
The spark ignition devices are not
Air in pipelines due to long period
A
FAULT
Important
For all requirements contact the agents or
the headquarters of Angelo Po which can
be found in the contacts section of the web-
site http://www.angelopo.com.
Causes
has gone out.
working.
out of use.
- 16 -
C
B
Remedies
Turn off the gas supply tap and
ventilate the room.
Check that the ignition devices
are in good working order. Light
by hand with a naked light.
Information
Contact the after-sales serv-
ice.
Make more attempts to light the
flame.
D
IDM-39603615700.tif
6