Linking The Robotic Mower And Docking Station - Stihl RMI 632 P Manual De Instrucciones

English
► Re-attach the cover as described in the "Installing the
docking station" section (@ 10.3) and press the OK
button on the control panel / manual controller.
► Connect the power supply plug to the electrical outlet and
press the OK button on the control panel / manual
controller.
When the perimeter wire is correctly installed and connected
to the docking station, a continuously red glowing LED (11)
will indicate that the docking stations is ready for operation.
► If the LED flashes red or remains off, the perimeter wire is
broken or not correctly connected to the docking station. It
could also indicate a malfunction in the docking station.
Check the perimeter wire or contact a STIHL iMow
servicing dealer.
12
► Lift the robotic mower slightly by the carrying handle (12)
and relieve the weight on the drive wheels. Do not lift by
the hood.
30
11
► Push the machine, resting on its front wheels, into the
docking station.
► Press the OK button on the control panel / manual
controller.

10.6 Linking the Robotic Mower and Docking Station

The robotic mower can only be operated if it receives the
wire signal emitted by the docking station.
Checking the wire signal may take several minutes.
► To terminate the linking process, push the STOP button.
The previous step of the installation assistant will be
called up again.
If the robotic mower and the docking station are
linked properly, the message "Wire signal OK"
and the symbol at left will be displayed.
► Continue the initial installation by pressing the OK button
on the control panel / manual controller.
Interrupted Reception
If the wire signal is interrupted or not received properly, the
display will show one of the following symbols:
The robotic mower is not receiving a wire signal.
The display shows the message "No wire
signal."
10 Installing the Robotic Mower
0478-131-3046-A