Corghi Artiglio Uniformity Manual De Uso página 132

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

High-performance wheels (asymmetric curvature) -
Fig. 22b: Some European wheels have rims with a very
pronounced curvature C, except in the area of the valve
hole A where the curvature is less pronounced B. On
these wheels the bead must first be broken in the area
of the valve hole, on both the top and bottom sides.
Wheels with pressure sensor - Fig.22c. To operate cor-
rectly on these wheels and avoid damaging the sensor
(which is incorporated in the valve, fixed with the belt,
glued inside the tyre, etc.) appropriate mounting/
demounting procedures should be followed (ref. Ap-
proved mounting/demounting procedure for runflat
and UhP tyres)
See the paragraph "TABLE FOR USING CENTRING ANd CLAMPING ACCESSORIES
ACCORdING TO RIM TYPE" in this manual.
AVOId PERSONAL INJURY
Never install or use centring and clamping accessories other than those indicated
in the "Tables for using centring and clamping accessories according to rim type"
When working with easily damaged wheels (wheels with
a central hole with thin, protruding edges - see Fig. 23),
we recommend using the universal turntable for blind
rims, (see the paragraph "TABLE FOR USING CENTRING
ANd CLAMPING ACCESSORIES IN RELATION TO WHEEL
TYPE" in this manual).
The TPMS device (optional accessory) can be used to check the proper operation
of pressure sensors.
Remove any old balancing weights from the rim.
132
CAUTION!
CAUTION!
CAUTION!
CAUTION!
A
B
A
Artiglio Uniformity User Manual
C
22b
B
C
22c
23

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido