Mounting Tubeless Tires; Use The Bead Presser As A Mounting Help Device - Hofmann monty 3300 Manual De Operador

336.tif
5.2-1
36
monty 3300 / 3300AIR
5.2-2
5.2-3
5.2-4
5.2-5

5.2 Mounting tubeless tires

A. Lubricate the entire rim surface (Fig. 5.2-1).Lubricate
both beads, inside and outside, (Fig. 5.2-2).
OBSERVE THE ROTATION DIRECTION OF THE TIRE,
IF REQUIRED. SOME TIRES HAVE A COLOR DOT
THAT MUST BE KEPT ON THE OUTSIDE OF THE
WHEEL.
LIBERAL LUBRICATION OF THE TIRE AND RIM IS
NECESSARY TO MOUNT TIRE CENTERING
337.tif
CORRECTLY AND GET A PROPER ON THE RIM. BE
SURE YOU ARE USING APPROVED LUBRICANT
ONLY.
B. Lock the rim on the turntable and rotate it to have
the valve in 5 o'clock position. Place the tire to be
mounted on the rim. Swing the mounting arm forward
so that the mount/demount tool is in the working
position.
ENSURE THAT THE MOUNT/DEMOUNT TOOL IS NOT
PRESET TO A WRONG POSITION SOTHAT IT WILL
HIT THE RIM EDGE AND CREATE AN HAZARD, BE-
FORE TILTING THE COLUMN FORWARD.
338.tif
C. Engage the lower bead OVER the mounting wing
and UNDER the mounting finger of the mounting tool.
Turn the wheel clockwise and push the tire down into
the drop centre, opposite to the mount/demount head
(Fig. 5.2-3).
D. Mount the upper bead following the same directions
(Fig. 5.2-4). With low profile tyres the bead depressor
device "easymont pro" can help to facilitate mounting
of the top bead.
905.tif
5.2.1 Use the Bead Presser as a mounting
help device.
A. Mount the first bead.
Position the roller (Item 1) and the bead pusher tool
(Item 2) as showed in Fig. 5.2-5.
B. Lower the bead pusher so that the roller and the
bead pusher tool on the tire help keeping the bead into
the drop center (Fig. 5.2-4).
The bead pusher tool follows the tire rotation during the
mounting operation.
Bring the roller and the bead pusher tool back to rest
position.
930.tif
Operator's Manual
USA - CANADA