Beading The Tires - Hofmann monty 3300 Manual De Operador

monty 3300 / 3300AIR
USA - CANADA

5.4 Beading the tires

Beading means the initial grip of the tire bead on the
rim, in order to allow the inflation operations and
subsequent settling in the seat on the rim.
Safety Precautions:
WARNING: DO NOT USE THE TIRE CHANGER TO
INFLATE TIRES.
COMPRESSED AIR DEVICES ON THE TIRE
CHANGER ARE ONLY DESIGNED TO FACILITATE
THE TUBELESS TIRE BEADING OPERATION.
NEVER EXCEED THE MAXIMUM PRESSURE
ALLOWED BY THE TIRE MANUFACTURER.
THE OPERATOR MUST STAND CLEAR FROM THE
WHEEL WHEN BEADING THE TIRE, AND
PRESSURE MUST BE MONITORED FREQUENTLY
TO AVOID EXCESSIVE PRESSURE.
BEFORE BEADING, CHECK THE CONDITION OF
TIRE AND RIM.
CHECK FOR CORRECT SEALING BETWEEN THE
VALVE AND THE FITTING AT THE END OF THE AIR
HOSE. AN AIR LEAK CAN GIVE INCORRECT
PRESSURE READINGS AND CREATE SAFETY
HAZARDS
CHECK THAT THE READING ON THE PRESSURE
GAUGE IS "ZERO" WHEN IT IS NOT IN USE.
THE COMPLETE SEATING THE BEAD ON THE RIM IS
A VERY DANGEROUS STAGE OF THE TIRE
MOUNTING PROCEDURE.
TO COMPLETE THE BEADING OPERATION AND
INFLATE THE TIRE CORRECTLY, PLACE IT IN AN
APPROPRIATE TYPE APPROVED CAGE.
A TIRE BURST, WHATEVER ITS CAUSE, CAN
RESULT IN SERIOUS INJURY OR DEATH.
AVOID MOUNTING TIRES THAT ARE 1/2" SMALLER
IN DIAMETER THAN THE RIM, DOING SO FAILS TO
ENSURE THAT THE BEADS ARE SEALED
PROPERLY IN THEIR SEATS: THIS COULD BE A
SOURCE OF DANGER WHEN DRIVING.
42 Operator's Manual