Maintnance - Hofmann monty 3300 Manual De Operador

R
G
T
46
monty 3300 / 3300AIR
6.0-1
6.0-2
6.0-3
F
S
6.0-4
6.0 Maintenance
BEFORE ATTEMPING ANY MAINTENANCE OR
REPAIRS
DISCONNECTED FROM THE AIR AND ELECTRIC
SUPPLY.
A. Periodically clean the vertical hexagonal rod with
nonflammable liquid detergent. Lubricate with oil (Fig.
6.0-1).
B. Periodically clean the turntable with a nonflammable
liquid detergent, dry and lubricate the sliding surface of
the clamps with oil.
1045.tif
C. Clean the teeth of the clamps (A) with a wire brush,
check the plastic rim protectors (B) and replace if worn
(Fig. 6.0-2).
D. Periodically wash all plastic parts with cold water
and soap or mild chemical detergent.
E. Periodically lubricate rods of air cylinders with oil.
F. Grease every 4 months the shaft that connects the
1011.a.tif
column to the cabinet. Add grease through the greasing
nipple (Fig.6.0-3).
G. Check the bead breaker pads. Replace if worn.
H. Check and discharge the water every day from air
filter/ water separator 'F'. Do this by pulling down the
fitting "S" (Fig. 6.0-4).
I. The machine is equipped with an automatic lubricator.
Check the oil level weekly. When adding oil to the
lubricator, disconnect the air supply first, remove the
561.a.tif
cup (T, Fig. 6.0-4) by twisting 1/4 turn counter
clockwise, and add oil as needed. Make sure seals
are in place when repositioning the cup.
USE ONLY OILS FOR AIR DEVICES, DO NOT USE
BRAKE FLUID OR OTHER NON RECOMMEND
LUBRICANTS.
Suggested oils for the filter/lubricator unit:
WHITE MINERAL OIL: 15 cSt
TAMOIL : WHITE MINERAL OIL 15
SHELL : ONDINA OIL 15
BP : ENERGOL WT3
TOTAL : LOBELIA SB 15
ESSO : MARCOL 82
1059.tif
Operator's Manual
THE MACHINE MUST
USA - CANADA
BE