Filling The Coolant; Motor Settings; Changing The Throttle Control Cable - SHERCO SE 250i Manual De Propietario

SE 250i / 300i
Cooling system (continued)

Filling THe COOlanT

Motor settings

CHanging THe THrOTTle COnTrOl Cable

n Throttle control
1
2
84
3
- Remove the bleed screw
side of the radiator
- Pour the coolant into the radiator through the
cap .
1
Coolant
Allow the coolant to flow through the screw
until there are no bubbles, replace the screw
using a new gasket.
Radiator bleed
screw
- Continue filling.
- Fill until the coolant reaches the level (approxi-
mately 1.1 liters)
- Put the bike on the side stand and follow the
rest of the filling procedure (
- The throttle control has two settings : direct or
progressive
located on the left
2
Minerva Perma Universal
D 4 -25°C
M6X8 8Nm
p.82)
☛
2
3