Checking The Play In The Throttle Cable - SHERCO SE 250i Manual De Propietario

Motor settings (continued)
n Changing the throttle control cable travel

CHeCKing THe Play in THe THrOTTle Cable

n Checking the throttle cable play
n adjusting the play in the throttle cable
1
- Remove the throttle control cable reel
the throttle tube
2
direct throttle control :
Install the throttle cable control reel with "CROSS"
facing the center of the bike.
Progressive throttle control :
Install the throttle cable control reel with
"ENDURO". Facing the center of the bike
With the handlebars facing straight ahead, check
that the throttle twist grip functions properly.
Throttle cable play
If the cable play is not correct, adjust the
accelerator throttle cable play. (
Start the bike and let it run at idle. Turn the hand-
lebars and check that the idle speed is constant.
If the speed changes, readjust the play in the
throttle cable. ( p.85)
☛
Adjust the throttle cable play at the location
shown with the adjuster.
1
If this is not enough, adjust the play directly on
the throttle body.
from
1
2....4mm
p.85)
☛
85