Replacing The Main Fuse; Replacing The Fuse For The Lights (Se 250/300I); Removing The Headlight Housing - SHERCO SE 250i Manual De Propietario

SE 250i / 300i
electrical system maintenance (continued)

rePlaCing THe Main FUse

rePlaCing THe FUse FOr THe ligHTs (se 250/300i)

1

reMOving THe HeadligHT HOUsing

1
2
116
Remove the seat (
The main fuse
1
Remove the defective fuse and replace with a
new fuse of the same value.
Main fuse 30A
Put a new spare fuse in the reserve location in
the fuse box.
- Replace the saddle (
Remove the seat (
The light fuse
the wiring harness on the right side of the bike.
Remove the defective fuse and replace with a
new fuse of the same value.
Light fuse 15A
- Replace the saddle (
Turn the ignition to the off position.
Unclip the left and right rubber fastners
each side of the fork.
Separate all of the brake hoses / cables from the
meter bracket at the top and bottom.
Move the top plate up to clear the housing.
Disconnect the connector
theheadlight housing.
p.96)
☛
is on a relay by the starter.
1
p.96).
☛
p.96)
☛
is located in a high location on
1
p.96).
☛
and remove
2
on
1