Operation; Symbol Reference; Device Navigation; Switching On The Device - BRAND HandyStep touch Instrucciones De Manejo

7 Operation

7 Operation
Possible damage to health caused by pathogenic liquids or infectious germs.
>
>
Device damage caused by incorrect use.
>
Submerge only the tip into a liquid.
>
If the device comes into contact with a liquid, clean it immediately.
>
Hang the device upright in the holder provided.

7.1 Symbol reference

See Symbol reference, p. 107.

7.2 Device navigation

See Device navigation, p. 107.

7.3 Switching on the device

a. Press the power button.
ð The main menu opens.
Start Motor Init
If using the device after a long period of non-use, you will be prompted to perform a motor initializa-
tion after switching on the device:
a. Confirm the message "Start Motor Init."
ð Motor initialization is carried out.
ð The device moves the tip adapter into working position.
ð The main menu opens.
Charging stand/USB cable
The device switches on when it is placed in the charging stand or when the USB cable is connected.
This also stops standby mode.

7.4 Switching off the device

a. Drain and eject the tip, see Dispensing liquid, p. 80 or Ejecting the tip, p. 78
b. Press the power button.
ð A message appears asking if you would like to switch off the device. Confirm by tapping
by tapping
c. If the power button is pressed for approx. 1 s, the device goes into standby.
If the power button is pressed for longer than 2 s, you are asked if you would like to switch off the
device.
76
Operating manual
Wear appropriate protective gear.
When handling the above-mentioned media, please observe the national regula-
tions, safety data sheets, the protection level of your laboratory and safe working
measures.
.
WARNING
NOTICE
HandyStep® touch, HandyStep® touch S 997486
. Cancel