Display; Sound; Info/About; Regulatory Notes - BRAND HandyStep touch Instrucciones De Manejo

8 Settings

8.4 Display

Brightness
Display time out
Auto power off

8.5 Sound

Event sound
When an event occurs, the device makes a sound. This event sound cannot be switched off.
Notification sound
STEP button sound

8.6 Info/about

Version
Date
Bootloader

8.7 Regulatory notes

Information about approvals can be found via this menu item.

8.8 Calibration

Prerequisite:
> You have just tested the device and would like to be reminded of the next device test. This way
you ensure that your device is inspected on a regular basis.
a. Set the date of the last test. This date can be in the past, present or future.
b. Set the date of the next test. This date must be in the future.
c. Activate the reminder via the slide switch.
ð If the test interval has expired, you will be reminded of the new device inspection via a message in
the display.
ð It is best to set these dates immediately after an inspection has been completed.
82
Operating manual
Adjust the brightness level via the slide switch.
Set the amount of time before the display first dims and
then turns off.
Set whether the device switches off by itself after 60 min-
utes in standby mode.
NOTICE
Enable sound alerts for program events.
Enable sounds when the STEP button is pressed.
Firmware version
The date the firmware was generated.
Software tool
1 Activate reminder
2 Illogical entries are shown in red. In this case, the last
1
test date lies in the future.
2
3 Set the last date on which the device was tested.
3
4 Set the next date on which the device is to be tested.
4
HandyStep® touch, HandyStep® touch S 997486