Tabla de contenido
Publicidad
5. Arrange the bunches according to size from thickest to the thinnest
conductive cushions.
6. Si más de un cable debe pasar a través de un pasacables, séllelo aplicando Loctite
5221 (número de catálogo 25551) en su interior.
6. If more than one cable go through a grommet, seal the grommet by
￭
Tendido de los cables de control en el interior del armario
5221 (catalogue number 25551) inside the grommet.
A continuación se muestra el recorrido de los cables de control en el bastidor R9. El recorrido
es similar en los bastidores R6, R7 y R8.
Routing the control cables inside the cabinet
Use the existing trunking in the cabinet wherever possible. Use sleeving
against sharp edges. When running cables to or from the swing-out fram
slack at the hinge to allow the frame to open fully.
Connecting to the inverter control unit (A41)
Connect the conductors to the appropriate terminals (see page 127) of
terminal block X504 (option +L504).
Connect the inner twisted pair shields and all separate grounding wires
clamps below the control unit.
The drawing below represents a drive with additional I/O terminal block
Without the block, the grounding is made the same way.
Notes:
•
Do not ground the outer shield of the cable here since it is grounded
through.
•
Keep any signal wire pairs twisted as close to the terminals as poss
wire with its return wire reduces disturbances caused by inductive c
Instalación eléctrica 93
Publicidad
Tabla de contenido
