Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
• Uninstalling ISOFIX system
1. To free the ISOFIX anchoring, pull the ISOFIX system unlock buttons
(P)
and
(Q)
in order to free the seat from the vehicle ISOFIX anchoring
system (fig. 4.6)
• Support leg installation
1. Unfold the support leg (Q).
2. Press the support leg button
correctly installed. The support leg will be correctly adjusted if the
indicators turn from red to green when the leg is fixed against the floor
of the vehicle.(fig. 4.7).
3. Shake the seat to check that it is correctly anchored to the vehicle's seat
(fig. 4.8).
5. FORWARD FACING INSTALLATION
76-105 cm. From 12 months to 4 years
NOTICE
approx. (10-16 Kg)
IMPORTANT! Do not use forward facing installation before the child´s age
exceeds 15 months.
1. Recline the seat to recline position 1, 2, 3 or 4 for forward facing
installation (fig. 5.2).
2. Unlock the ISOFIX arms
(M)
3. If your vehicle has not been fitted with the ISOFIX latch guides as
standard, fit the two latch guides
4.3).
TIP: The ISOFIX fastening points are located between the surface and the
backrest of the vehicle seat.
5. Place the seat in the back seat of the vehicle (fig. 4.4).
6. Hold the safety seat with both hands and insert the two ISOFIX arms
(M)
firmly into the insertion guides
on both sides. The red button will partially change to green on both
sides(fig. 4.5).
7. Shake the seat to check that it is correctly anchored to the vehicle's
ISOFIX points.
24
(R)
to adjust the height. The leg will be
by pulling the strap
(O)
(fig. 4.2).
(S)
that came with the safety seat (fig.
(S)
until they fasten with a click
• Uninstalling ISOFIX system
1. To free the ISOFIX anchoring, pull the ISOFIX system unlock buttons
(P)
and
(Q)
in order to free the seat from the vehicle ISOFIX anchoring
system (fig. 4.6)
• Support leg installation
1. Unfold the support leg (Q).
(R)
2. Press the support leg button
correctly installed. The support leg will be correctly adjusted if the
indicators turn from red to green when the leg is fixed against the floor
of the vehicle (fig. 5.4).
3. Shake the seat to check that it is correctly anchored to the vehicle's
seat (fig. 4.8).
6. T-PAD
It is a lumbar support that favors the child to go in a more natural and
ergonomic recline position. Especially in the first months of the child. (fig. 6.1)
CAUTION! Use this support until the child reaches 6 kg of weight. Once this
weight is exceeded, remove it from the seat.
7. REMOVING THE COVER
Follow the following steps for remove the cover:
1. Recline the seat to the position 1 (fig. 7.1).
2. Loosen the harness straps by pulling them at the point where they cover
the chest while pressing the harness adjustment button
3. From the back of the seat, remove the harness straps as shown in fig. 7.3.
(F)
4. Press the harness´ red button
5. Remove headrest cover (fig. 7.5).
6. Remove seat cover (fig. 7.6).
to adjust the height. The leg will be
(G)
(fig. 7.2).
to unlock the harness´straps (fig. 7.4).
25
Publicidad
Tabla de contenido
