Adjusting Burner Primary Air (0*1Fr3Gd - 1*1Fr4Gd); Replacing Parts; Instructions And Warning For Replacing Parts; Replacement Of The Burner Nozzle - Angelo Po 0N1FR1GD Manual De Uso

ADJUSTING BURNER PRIMARY AIR (0*1FR3GD - 1*1FR4GD)

To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Open the hatch (A).
2)
Undo the locking screw (B).
3)
Set the bush (C) at the distance as shown in
4)
the fi gure.
Tighten the screw (B).
5)
After making the setting, seal the screw with
paint.
Close the door (A) when the operation is
6)
complete

INSTRUCTIONS AND WARNING FOR REPLACING PARTS

Important
Before carrying out any replacement proce-
dure, activate all the safety devices provided
and decide whether staff at work and those in
the vicinity should be informed. In particular,
turn off the gas supply tap and prevent access
to all devices which might cause unexpected
health and safety hazards if turned on. If work
parts have to be replaced, use original spare
parts only.
To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Open the hatch (A).
2)
Unscrew the nozzle (B) and replace it with
3)
the one suitable for the type of gas in use (see
table at back of manual).
Close the door (A) when the operation is
4)
complete.
3301390_inst_GB_rev.2

REPLACING PARTS

REPLACEMENT OF THE BURNER NOZZLE

A
The manufacturer declines all responsibly for
injury or damage to components due to the
use of non original parts, or extraordinary
work on the appliance which may modify the
safety requirements without the manufac-
turer's authorisation. When ordering compo-
nents, follow the instructions provided in the
parts catalogue.
A
- 15 -
B
B
ENGLISH
GB