Safety Devices; Transport; Installation; Installation Place - ATT NUSSBAUM TC 205 Manual De Instrucciones

ENGLISH • Instructions manual

4. SAFETY DEVICES

TC 205 / Liga C 220 tyre changer is equipped with a pneumatic built-in safety valve.
This valve prevents pressure coming from inflating gauges, or other inflating devices connected to the tyre changer, to exceed 3.5 bar.
WARNING: Removing or tampering with the safety devices is in violation of European safety regulations and
relieves the manufacturer from all liability for damage caused by or related to such actions.

5. TRANSPORT

The machine is delivered in a carton box with pallet.
Shipping weight is 256 kg.
The machine must be handled with a fork-lift truck with the forks positioned as shown in
A
the figure A.

6. INSTALLATION

6.1 INSTALLATION PLACE

Position the tyre changer, still in its packing, in the chosen installation site.
Remember that:
1- The machine's workplace requirements are 1340 mm wide x 1600 mm (depth) with at least 500 mm of clear space from any wall.
2- The floor must be solid, level and able to bear the weight of the machine without yielding.
3- The installation site must be equipped with an electrical system with an efficient grounding circuit and automatic differential circuit-
breaker with 30 mA setting.
4- The installation site must be equipped with a connection to a compressed air network with
an operating pressure of at least 8 bar.

6.2 UNPACKING

1 - Remove the tyre changer from the packing and check to make sure that the machine is in
a perfect condition. Make sure that there are no visibly damaged parts.
2 - Remove all the screws that fix the machine to the pallet, using a N° 13 setscrew wrench.
WARNING: Use the fixing plates (Fig. B), which locks the tyre changer on the pallet, for fixing
the machine on the ground after unpacking.
B
TC 205 - Liga C 220
23