baltur COMIST 36 Instrucciones página 46

APPLICATION OF THE BURNER TO BOILER for mod. COMIST 122
1 Boiler plate
 Flange with insulating materials
3 Seam with insulating materials
4 Burner securing flange
5 Stud bolts, washers and nuts for fastening to the boiler
6 Nuts screws and washers to fasten flange to the slee-
ve
COMBUSTION HEAD ASSEMBLY
To put in place insulation flange 2, which must be posi-
tioned between the burner and the plate of boiler 1, the
end of the combustion head must first be removed.
a) Adjust position of connector flange 4 by loosening
screws 6 so that the combustion head penetrates into
the combustion chamber the amount recommended
by the generator's manufacturer.
b) Position seal insulation 3 on the tube unit.
c) Fasten the combustion head assembly to the boiler 1 using the stud bolts,
washers and the nuts provided 5.
d) With suitable material, completely seal the space between the tube unit of the
burner and the hole on the refractory plate inside the boiler door.
46 / 139
0006080093_00709