Technical Data - Franke Smart Plus SMP 86 M XS/F Manual Del Usuario Y De Instalación

EN
Removing the side frames
Bend the crosspiece engaged in the fixing bush
X X
downwards and remove it from the groove.
Tilt the frame upwards by approx. 60° and push it
X X
slightly in the direction of inclination.
Keeping the frame tilted, remove the two top
X X
hooks from the respective holes.
Fitting the side frames
Keeping the frame tilted, insert the top hooks
X X
in the respective holes, pushing lightly in the
direction of inclination.
With the frame tilted, pull in the direction of
X X
inclination until the top hooks stop against the
outside of the compartment wall.
Turn the frame towards the compartment wall.
X X
Bend the crosspiece engaged in the fixing bush
downwards and remove it from the groove.

TECHNICAL DATA

Power supply voltage and frequency
Total power and fuse rating
Power and heating elements
Upper
Lower
Grill
Fan
Tangential fan
Oven lamp
SMP 86 M _/F
Replacing the oven lamp
Franke ovens are equipped with a circular lamp
positioned in the top left area at the back of the
compartment. To replace the oven lamp, proceed
as follows:
Turn off the power to the appliance by means of
X X
the omnipolar switch used for connecting it to
the electrical system, or disconnect the plug if
accessible.
Unscrew the glass cover (A).
X X
Unscrew the lamp and replace it with one
X X
resistant to high temperatures (300 °C),
with the following characteristics:
– Voltage: 220/240 V ~ 50-60 Hz
– Power: 25 W
– Connection: G9
Refit the glass cover (A) and reconnect the power
X X
supply.
220-240 V, 50/60 Hz
2850 W ~ 16 A
1000 W
1250 W
2250 W
30 W
15 W
1 x 25 W
– 14 –
A