Replacing Parts; Replacement Of The Burner Nozzle - Angelo Po 191BR1G Manual De Uso

RECOMMENDATIONS FOR REPLACING PARTS
Before carrying out any replacement procedure, ac-
tivate all the safety devices provided and decide
whether staff at work and those in the vicinity
should be informed. In particular, turn off the gas
supply tap and prevent access to all devices which
might cause unexpected health and safety hazards
if turned on. If work parts have to be replaced, use
original spare parts only. The manufacturer de-

REPLACEMENT OF THE BURNER NOZZLE

To carry out this operation,
proceed as follows.
1 - Turn off the gas supply
tap.
2 - Remove the knob
(B).
3 - Undo the screws
(C) and remove
the control panel (D).
4 - Unscrew the nozzle (E)
and replace it with the
one suitable for the type
of gas in use (see table
at back of manual).
IT
5 - Replace the control panel (D) and the knob (B)
on completion of the operation.
GB
REPLACING THE BURNER AIR BUSHING (291BR1G - 291BR2G - 291BR3G)
DE
To carry out this operation,
proceed as follows.
FR
1 - Turn off the gas supply
tap.
ES 2 - Remove the knob (B).
3 - Undo the screws (C)
and remove the control
panel (D).
4 - Undo the screw (E).
5 - Extract the bushing (F)
and replace it with the
one suitable for the
type of gas in use (see
table at back of manu-
al).
6 - Tighten the screw (E).
English

REPLACING PARTS

B B
C C
B
C
- 24 -
clines all responsibly for injury or damage to com-
ponents due to the use of non original parts, or
extraordinary work on the appliance which may
modify the safety requirements without the manu-
facturer's authorisation. When ordering compo-
nents, follow the instructions provided in the parts
catalogue.
D D A C C
D C
7 - Replace the control panel (D) and the knob (B)
on completion of the operation.
9
E E
IDM-39616002500.tif IDM-39616002500.tif
F E
IDM-39616002600.tif