Replacing Parts; Replacing The Oven Burner Nozzle - Angelo Po 1G1FA0GV Manual De Uso E Instalación

RECOMMENDATIONS FOR REPLACING PARTS
Before carrying out any replacement procedure, ac-
tivate all the safety devices provided and decide
whether staff at work and those in the vicinity
should be informed. In particular, turn off the gas
supply tap and prevent access to all devices which
might cause unexpected health and safety hazards
if turned on. If work parts have to be replaced, use
original spare parts only. The manufacturer de-
REPLACING THE TOP BURNER NOZZLE
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Remove the grid (A).
3 - Extract the burner (B).
IT
GB
DE

REPLACING THE OVEN BURNER NOZZLE

FR
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
ES
2 - Undo the screws (B) and remove the control
panel (A).
3 - Unscrew the nozzle (C) and replace it with the
one suitable for the type of gas in use (see table
at back of manual).
4 - Replace the control panel (A) on completion of
the operation.
English

REPLACING PARTS

A
B
- 24 -
clines all responsibly for injury or damage to com-
ponents due to the use of non original parts, or
extraordinary work on the appliance which may
modify the safety requirements without the manu-
facturer's authorisation. When ordering compo-
nents, follow the instructions provided in the parts
catalogue.
4 - Unscrew the nozzle (C) and replace it with the
one suitable for the type of gas in use (see table
at back of manual).
5 - Replace the burner and the grid.
B A
9
8
C
IDM-39618301600.tif
C
IDM-39606200400.tif