Description Of Display - Cebora WIN TIG DC Manual De Instrucciones

NOTICE: THE FIGURES LISTED IN THIS MANUAL
AND IDENTIFIED WITH A NUMBER ARE ACCES-
SIBLE IN THE ENCLOSED PUBLICATION CODE
3301036

4 DESCRIPTION OF DISPLAY

tory setting). The operator may start welding immediately and
may adjust the current by turning knob B.
As seen in the figure, the display is divided into sectors.
In each sector, settings operations may be conducted.
The main sector R is the only sector bordered with red.
To select and activate the functions of this sector, press
knob B, choose the function to be changed by turning
the knob, the selected functions will turn blue. The name
of the selected function appears on the upper left of the
display.
The welding process always appears at the top left
between the R and S sectors.
S
R
Q
P
With the function highlighted in blue, just press the knob,
the function turns red and the display shows a cursor
with the minimum, the maximum and the set value, to
change this value simply adjust it with the knob, to con-
firm it press the knob again. All other sectors are selected
only by touching them with the finger.
4.1 SECTOR R . ADJUSTMENT OF WELDING PARAM-
ETERS
The settings of the welding parameters are summarized
in the parameter setting table.
By way of example, The procedure for setting the PRE-
GAS time is described . Select the function (FIG.3), this
16
During
for 5 seconds the
display presents
all the information
regarding
welding machine
software versions.
The display then
presents
main screen (fac-
N V
O
will turn blue, turning it on using the knob it will turn red
(FIG.4), set the value and confirm, again by pressing the
knob.
For other adjustments, follow exactly the same proce-
dure.
4.2 SECTOR Q .CHOICE OF WELDING PROCESS
start-up,
Select sector Q with your finger (see FIG.5)
Select the TIG or MMA process (FIGS 6 and 7) with your
finger.
the Select the type of process with the knob, among those list-
ed:
TIG DC process see chapter 12
TIG DC APC process see chapter 11.
the TIG AC process see chapter 12-8.
TIG process MIX AC + DC see chapter 9.
MMA DC process (see FIG.7) see chapter 13.
MMA AC process (see FIG.7) see chapter 13.
The welding process always appears at the top left be-
tween the R and S sectors.
4.3 SECTOR P . CHOICE OF START-UP MODE
Select the sector P with the finger (see FIG.8).
You can select and activate the following modes: the ar-
rows indicate the movement of the pressure or release
of the torch button.
Two stroke manual mode (see FIG. 9 and FIG. 10)
Mode appropriate for brief welding or automated
T
I
Z
M
In manual 2-stroke mode, the spot-welding function
can also be enabled by selecting the SPOT sector (See
FIG.11 and FIG.12). In this way the welding machine is
automatically set up for high-frequency ignition.
To adjust the spot-on time, enter the MENU by pressing
on sector M (see FIG.13) and on the "Process parame-
ters" sector (see FIG.14); One entered in the submenu,
use the knob to select and activate the Spot function
time (see FIG.15-15A-15B and 16) and always use the
knob to adjust the value. Together with the spot function
you can also activate the pause welding function, this
is the time between one point and the other, select and
activate the function as for the spot time (see Figures
17, 18 and 19). Pause welding is widely used for those
who have to make aesthetic welds and do not want to
robotized welding.