Astralpool PROHEAT II Serie Manual De Instrucciones página 11

PROHEAT II SERIES · HEAT PUMP AIR/WATER SYSTEM
DANGER OF INJURY BY REFRIGERANT GAS:
Refrigerant gases may cause disorders in heart rate and frostbite in case of
body contact, ingestion or inhalation.
•
•
•
•
•
DANGER OF INJURY BY HOT SURFACES:
The surfaces of some components may become hot during operation of
the equipment. Contact with skin can cause severe burns.
•
DANGER OF INJURY BY COLD SURFACES:
The surfaces of some components may become cold during operation of
the equipment. Contact with skin can cause severe freeze-burns.
•
DANGER OF INJURY BY PRESSURIZED GASES:
Pressurized components of the equipment can leak fluids under high
pressure if they are handled incorrectly or in case of defect and cause
serious injuries.
•
DANGER OF INJURY BY FIRE:
If the fire extinguishing media is not ready for use or is inadequate, serious
injury or death may occur as well as serious material damages.
•
•
•
•
DANGER OF INJURY OR DEATH BY FAULTY SECURITY SYSTEMS:
If safety devices are not working correctly or have been tampered with or
manipulated, there is a risk of serious injury, even death.
•
•
•
© FLUIDRA 2019 ALL RIGHTS RESERVED. PROPRIETARY DOCUMENT.
Avoid contact with refrigerant gases.
Works on refrigeration systems must be carried out by qualified
personnel.
When working with refrigerants, do not eat, drink or smoke. Wash
your hands after finishing work.
Wear all necessary protection gear: clothing, gloves, glasses ...
Work in a ventilated place.
When working in the vicinity of hot surfaces, wear protection gear:
clothing and safety gloves.
When working in the vicinity of cold surfaces, wear protection gear:
clothing and safety gloves.
Before working with the pressurized elements, remove the
pressure.
Make sure that there is adequate extinguishing media at the site.
Check extinguishing media periodically.
Replace or replenish the extinguishing media after each use.
When using extinguishers, pay attention to the instructions for use.
Before starting any work on the equipment, check that all safety
devices are in working order and correctly installed.
Do not override or short circuit any safety device.
Make sure that all safety devices are accessible at all times.
ENGLISH
Pag: 11