Astralpool PROHEAT II Serie Manual De Instrucciones página 38

PROHEAT II SERIES · HEAT PUMP AIR/WATER SYSTEM
• Press to pass through all the periods and exit the menu.
NOTE: If the Schedule Program mode is activated and there are no periods scheduled, the
machine will not start.
5. Setting the machine operating mode
• Press to choose the machine operating mode (Heat, Cool and Automatic, only if
F29=3).
Press for at least 2 seconds to activate or deactivate the Schedule Programming
•
mode.
6. Checking the temperatures (Reading variables)
Press to display the temperature probe settings and compressor consumption
•
(3 settings for each phase of the compressor). Use
settings.
The values shown refer to the following nomenclature:
T1
Water inlet
Cool sensor 1
temperature (Defrost Probe)
.
T7
Aspiration Ambient
Probe 2 temperature
T13
Low Pressure High Pressure
circuit 1 (BAR) circuit 2 (BAR)
LP1
T19
Current Phase
Current phase
1-compressor 2
2-compressor 2
NOTE: The compressor consumption settings vary depending on water and outside
temperature and the settings of phase consumptions does not have to be the same.
© FLUIDRA 2019 ALL RIGHTS RESERVED. PROPRIETARY DOCUMENT.
T2 T3
Compressor 1
discharge
temperature
T8 T9
Water outlet
temperature
T14 T15
Low Pressure
circuit 2 (BAR)
HP2 LP2
T20 T21
Current phase.
3-compressor 2
or to display the various
T4 T5
Sonda de Cool sensor 2
Aspiración 1 (Defrost Probe)
T10 T11
Valve steps Valve steps
circuit 1 circuit 2
T16 T17
Current Current
phase 1- phase 2-
compressor 1 compressor 1
ENGLISH
T6
Discharge
probe 2
T12
High Pressure
circuit 1 (BAR)
HP1
T18
Current phase
3-compressor
1
Pag: 38