Checking The Packaging; Electrical Connections - Astralpool PROHEAT II Serie Manual De Instrucciones

PROHEAT II SERIES · HEAT PUMP AIR/WATER SYSTEM

8. CHECKING THE PACKAGING

This equipment comes with RECYCLABLE packaging that can withstand rough transport
conditions. However, you should examine the device during installation to ensure there is no
damage, thus avoiding any subsequent malfunction.
The MANUFACTURER will not be held responsible in this case
IS VERY IMPORTANT TO KEEP THE PACKAGED EQUIPMENT UPRIGHT, THE PACKAGING HAS
BEEN SPECIFICALLY DESIGNED FOR THIS. ALWAYS MAINTAIN IT IN A VERTICAL POSITION.
IF THE UNIT IS DAMAGED, OR THE DELIVERY IS INCOMPLETE, MAKE A NOTE OF IT ON THE
CARRIER'S BILL AND IMMEDIATELY MAKE A CLAIM TO THE COMPANY IN CHARGE OF DELIVERY.
Inside the parcel you will find the following elements:
Pool heating equipment
Installation manual.
Warranty.

9. ELECTRICAL CONNECTIONS

The electrical connection must be carried out by the fitter taking the following points into
account:
• Please perform the connection according to the circuit diagram included in this manual.
• Place a differential circuit breaker in the general power connection to protect the
equipment from possible grounding problems. The differential breaker should be
minimum 30 mA.
• Differential breaker.
• Automatic or circuit breakers.
• Before connecting the equipment, you must check that the electrical installation is
disconnected and that there is no voltage between the power supply phases.
Connect the lead-in wires to the machine's input terminal.
•
• Connect the ground wire to the relevant terminal.
• The provision of any legislation in force with respect to any electric lines against direct
or indirect faults and contacts must be followed at all times.
Verify the tightness of all electrical connections.
•
You must check that the electrical resistance between the ground and any electrical
•
terminal is over 1 megaohm. If not, the equipment cannot be started up until the
electrical loss may be located and repaired.
• If there are fluctuations of the input voltage, it is recommended to install a voltage
stabilising system to prevent damaging the equipment.
• The illustration below shows a diagram of a proper connection.
© FLUIDRA 2019 ALL RIGHTS RESERVED. PROPRIETARY DOCUMENT.
ENGLISH
Pag: 40