Changing The Metering Mode (Metering Mode) - Canon EOS REBEL T6S Manual De Instrucciones

q Changing the Metering ModeK
Four methods (metering modes) to measure the subject's brightness
are provided. Normally, evaluative metering is recommended.
In Basic Zone modes, metering mode is set automatically.
126
Select [Metering mode].
1
Under the [z2] tab, select [Metering

mode], then press <0>.
Set the metering mode.
2
Select the desired metering mode,

then press <0>.
Evaluative metering
q
General-purpose metering mode suited even
for backlit subjects. The camera sets the
exposure automatically to suit the scene.
Partial metering
w
Effective where there are much brighter lights
around the subject due to backlight, etc. The gray
area in the left figure is where the brightness is
metered to obtain the standard exposure.
Spot metering
r
Effective when metering a specific part of the subject
or scene. The gray area in the left figure is where the
brightness is metered to obtain the standard
exposure. This metering mode is for advanced users.
Center-weighted average metering
e
The brightness is metered at the image center
and then averaged for the entire scene. This
metering mode is for advanced users.