Installing And Removing The Card - Canon EOS REBEL T6S Manual De Instrucciones

Installing and Removing the Card

The card (sold separately) can be an SD, SDHC, or SDXC memory
card. SDHC and SDXC memory cards with UHS-I can also be used.
The captured images are recorded onto the card.
Make sure the card's write-protect switch is set upward to
enable writing and erasing.
Installing the Card
Write-protect switch
Possible shots
The number of possible shots depends on the remaining capacity of the

card, image-recording quality, ISO speed, etc.
Setting [z1: Release shutter without card] to [Disable] will prevent

you from shooting without a card inserted.
Open the cover.
1
Slide the cover as shown by the

arrows to open it.
Insert the card.
2
As shown by the illustration, face

the card's label side toward you
and insert it until it clicks in place.
Close the cover.
3
Close the cover and slide it in the

direction shown by the arrows until it
snaps shut.
When you set the power switch to

<1>, the number of possible shots
will be displayed on the LCD panel.
35