Canon EOS REBEL T6S Manual De Instrucciones página 196

Connecting with the NFC Function
The settings for communicating with a smartphone are now complete.
NFC Function Cautions
When touching the smartphone to the camera, be careful not to drop the

camera or smartphone.
Do not touch the smartphone to the camera with too much force. Doing

so can scratch the camera or smartphone.
Just holding the smartphone close to the mark may not establish a

connection. Be sure to touch the mark with the smartphone so that they
come into contact with each other.
Recognition may be difficult depending on the smartphone. Touch slowly

while changing the position or angle.
Another application on the smartphone may start depending on how you

touch. Check the position of the p mark, then touch again.
A connection cannot be established via the NFC function while shooting

with the camera, when the power switch is set to <k>, when there is no
card, or when the LCD monitor is closed with the screen facing inward.
When touching the smartphone to the camera, do not leave anything

between the camera and smartphone. In addition, when a case is
attached to the camera or smartphone, communication may not be
possible via NFC function.
When Battery Grip BG-E18 (sold separately) is attached, a connection

cannot be established via the NFC function.
The camera cannot be connected to two or more smartphones at the

same time.
By default, the connection settings via the NFC function are saved as the

fourth setting (a setting dedicated to NFC connection) under the name
[SET4(NFC)]. When you connect the camera to another smartphone via
NFC, [SET4(NFC)] will be overwritten.
A connection can be established even when the camera's power is in the

auto power off state. However, if a connection cannot be established,
cancel auto power off, then establish a connection.
W-22
Operate the Camera using
3
Camera Connect.
Perform further operations using

Camera Connect. For the operation
procedure, see page W-27.