John Bean B 2000P Manual Do Operador página 156

6-90
1
6-91
6-92
156
1
2 3
1
2
3
4
5
6
"OPTI LINE"
WHEEL No. 1
Once the run is finished:
The balancer completes the program readings, then
the rear laser scanner scans the tread to acquire the
conicity indices.
The icon indicating the tread conicity angle appears
on the Information field of the screen (1, Fig. 6-90).
The meanings of the icons are as follows (Fig. 6-91):
1) Tread conicity reading with pull towards LEFT.
2) Tread conicity reading with NEUTRAL pull.
3) Tread conicity reading with pull towards RIGHT.
• Balance the planes and make any corrections.
• Remove the wheel from the balancer.
Access the "Set of Wheels" screen.
• Press (1, Fig. 6-90)
The screen shows a number and a colour assigned to
the wheel, useful for identifying it until the procedure
is complete (Fig. 6-92).
From this moment the keys in the Menus have the
following functions (Fig. 6-92)
On right side screen Menu:
1 ENTER a wheel without direction constraints,
which can therefore be used on either side of the
vehicle.
2 ENTER a wheel which can be mounted only
on the left of the vehicle; tyres with mandatory
direction.
3 ENTER wheels which can only be mounted on
the right of the vehicle; tyres with mandatory
direction.
4 Deletes the current Set and starts a new "Set of
Wheels".
5 EXIT the OPTI LINE Mode. The machine returns
to the OPTIMA ENTRY screen and stands by for
further commands.
6 RETURN to the previous step, so that you can
assign the wheel a different use in the Set.
To continue,
Select one of the items 1, 2 or 3 to add the
•
wheel to the Set, assigning the mandatory side
mounting position if necessary (2 or 3).
.. ..........
_