John Bean B 2000P Manual Do Operador página 160

6-90
6-96
6-97
6-98
160
1
"OPTI LINE"
WHEEL No. 2
• Mount the wheel on the balancer shaft.
• Perform the run.
• Balance the planes and make any corrections
suggested.
• Remove the wheel from the balancer.
• Access the "Set of Wheels" screen (1, Fig. 6-90).
The screen page shows the wheel with the number after
the previous one and a different colour (1, Fig. 6-96).
• Select one of the key to enter the current wheel
in the set.
The "SET OF WHEELS 2" screen page appears
automatically (Fig. 6-97).
Note: After having assigned the wheels twice to one
side of the vehicle, the program does not allow you
to select this key again.You cannot assign more than
two wheels to the same side of the vehicle.
WHEEL No. 3
•Perform the procedure as described for wheel No.
2.
WHEEL No. 4
•Perform the procedure as described for wheel No.
2.
At this point of the procedure the machine already has
a first mounting suggestion.
The image of the vehicle on the right shows the number
and color of each wheel, in the mounting position
required to reduce the PULL or the Vibrations (Fig.
6-98).
You can now select one of these options:
"Optimise vibrations",
"Enter fifth wheel"
"Start a new Set of Wheels", or
"Terminate and exit procedure"
as described below.
.. ..........
_