John Bean B 2000P Manual Do Operador página 192

8
7-41
7-42
7-43
7-44
192
Operation
Reading of error code E9
If E9 is read out, at least one error was made with
respect to the sequence of operations when performing
optimisation (System messages
— Abort the optimisation program by pressing
the STOP key and, if desired, start optimisation
once again.
Fig. 7-41 OPTIMISATION "12"
(4th measuring run of tyre/rim assembly)
Clamp the wheel on the balancer.
—
Rotate the wheel such that the valve is exactly
—
perpendicular to and above the main shaft.
Confi rm the valve position by pressing key 8.
—
The OPTIMISATION "13" screen (Fig. 7-42) is
displayed.
Fig. 7-42 OPTIMISATION "13"
START is displayed on the screen.
Spinn the wheel.
—
A measuring run is performed.
The BALANCING screen (Fig. 7-43) is displayed.
Finish weight Optimisation
Fig. 7-43 BALANCING
Balance the wheel according to the readings.
—
Fig. 7-44
If the wheel running conditions are optimal, the
following codes can be displayed:
H0 Wheel running conditions cannot be improved by
optimisation.
H1 Further optimisation not recommended but
feasible.
H2 Weight minimisation is recommended, optimisation
can achieve no further improvement.
.. ..........
_
9.1).
F