John Bean B 2000P Manual Do Operador página 58

58
H82
The self–test was disturbed (e.g. by rotating the
wheel).
The message is displayed for 3 seconds, after which
the measurement is repeated (max. 10 times), or
aborted by pressing the STOP key or the ESC key.
H948
H949
Fault during self-test at start-up.
The firmware is not aligned with the User Interface
version currently in use.
Note:
Wheel balancer operation is not compromised.
You can continue using the machine.
—
Consult the technical assistance department for
—
f urther information.
Fatal error codes
The self–test program has detected an error and
displays a alphanumeric code consisting of six digits
and/or letters.
C10 800
Line voltage under 170 V. Balancing is feasible if
the motor can drive the main shaft to the measuring
speed. Wheel data may be lost.
Bring the line voltage to within a range of 200
—
- 230 - 240 Volts with an input transformer (ref.
6705 902).
C10 801
Line voltage over 265 V. Damage to the electronic
unit of the machine is likely!
Turn off mains switch!
—
Bring the line voltage to within a range of 200
—
- 230 - 240 Volts with an input transformer (ref.
6705 902).
Any damage resulting from repeated occurrence of
this error code is not covered by the guarantee.
C10 804
Line voltage over 275 V. Damage to the electronic
unit of the machine is likely!
Turn off mains switch!
—
Bring the line voltage to within a range of 200
—
- 230 - 240 Volts with an input transformer (ref.
6705 902).
Any damage resulting from repeated occurrence of
this error code is not covered by the guarantee.
.. ..........
_