Gima CMS-M Manual Del Usuario página 32

4.1.2 SpO
2
1) Connect the oximeter probe to the device.The probe is limited to be
produced by our company; never replace it with the similar ones by other
manufacturers.
2) Put the finger into the probe.
3) Press the "Power switch" long to open the device, it will enter the SpO
measurement Interface.
4) Under measuring interface,the user could read the correlative data from
display screen.
5) Press the "Power switch" Long to turn off the device after measuring.
Fig. 4-1 SpO monitor interface
2
Attention:
 Please check the device before using, and confirm that it can work normally.
 The fingernails of the testee should not be too long.
 Testee can not use enamel or other makeup.
 As to the fingers which are too thin or too cold, it would probably affect
the normal measure of the patients' SpO
finger such as thumb and middle finger deeply enough into the probe.
 Do not shake the finger and keep the patient in a stable state during using
process.
 Fingernails and the luminescent tube should be on the same side
(as Fig. 4-1).
 Excessive ambient light may affect the measuring result. It includes
fluorescent lamp, dual ruby light, infrared heater, direct sunlight, etc.
 There shouldn't be rubber fabric and so light barrier on the way of light,
or else it may result in venous pulsation and inaccurate measure of SpO
and pulse rate.
 The SpO sensor and photoelectric receiving tube should be arranged
2
in a way with the subject' s arteriole in a position there between.
 The SpO sensor should not be used at a location or limb tied with arterial
2
canal or blood pressure cuff or receiving intravenous injection.
ENGLISH
and Pulse Rate Measurement
and pulse rate, please clip the thick
2
32
2
2