Setting Of The Y Scale - JUKI LK-1942ZA5050 Manual De Instrucciones

130524
(3) Setting of the scale
Setting of the X scale
PATTERN No.
X-SCALE
Y-SCALE
SPEED
COUNTER
WINDER
THREAD
CUTTER TEMP

Setting of the Y scale

PATTERN No.
X-SCALE
Y-SCALE
SPEED
COUNTER
WINDER
THREAD
CUTTER TEMP
(4) Setting of the max. sewing speed limitation
PATTERN No.
X-SCALE
Y-SCALE
SPEED
COUNTER
WINDER
THREAD
CUTTER TEMP
(5) Finish of setting
Use after checking the pattern No. Press the sewing ready switch while No. other than
the service pattern is indicated on the display, and the error No. E-1 will be shown. At this
time, set again the pattern No. which has been registered.
Press
press the key earlier, error display E-5 will be displayed. If this error is displayed, reset the
error display by pressing
SEWING
key at least four seconds after having turned ON the sewing machine. If you
key again.
1) Press the key to indicate the item "X
Scale".
2) Press the or
range of 20% to 200%.
1) Press the key to indicate the item "Y
Scale".
2) Press the or
range of 20% to 200%.
Enlargement/reduction is a mode
of enlargement/reduction of stitch
length. When enlargement/reduction
is performed, the number of stitches
is fi xed and the stitch length varies.
1) Press the key to indicate the item "Speed".
2) Press the or
the display. (Setting of 400 sti/min)
1) Press the key.
2) The feeding frame comes down and moves.
Then, after it has been raised, the sewing LED
lights up, and the sewing is ready.
※ If the key is pressed, you can make sure
the set value of the respective items again.
– 7 –
key to set the scale in the
key to set the scale in the
key to indicate " "on