Publicidad
130524
*. LIST OF ERRORS
1. Reading the error indication
When a fault occurs, the corresponding error code will be output on PLC inside the heat cutter control box.
Check the error code following the steps of procedure described below.
control panel
Selected
device
DM
Specifi ed value
2. List of error codes
(1) List of error codes for the device
Error code
1
2
10
11
12
20
21
22
In the case two or more faults occur simultaneously, the error code number of which is smaller is displayed preferentially.
However, the error code "2" is an external error and is given the lowest preference.
After the cylinder sensor fault has occurred, the heat cutter will carry out origin retrieval
by resetting the fault with the "RESET" switch.
Inside of
Rear face of
control panel
Access window
Device
number
10
No.
Set value
Description
Temporary stop fault
Temporary stop switch has been
pressed.
Sewing machine fault A fault has occurred in the main
body of sewing machine.
Needle thread trim-
Operation end of the needle thread
mer cylinder sensor
trimmer cylinder could not be detect-
fault
ed.
Bobbin thread trim-
Operation end of the bobbin thread
mer cylinder fault
trimmer cylinder could not be detect-
ed.
Bobbin case holder
Operation end of the bobbin case
positioning fi nger
holder positioning fi nger cylinder
cylinder sensor fault
could not be detected.
Stitch skipping detec-
Stitch skipping has been detected
tion fault
during sewing
No bobbin-thread
Bobbin thread has run out during
fault
sewing
Bobbin setting fault
Bobbin setting position could not be
confi rmed after the replacement of
bobbin thread
1) Press the
ed device.
2) Set the device number to "10" with the
key.
Cause
Reset the temporary stop switch. Then, press the "RE-
SET" switch.
Correct the fault referring to the Instruction Manual for the
main body of sewing machine.
Check for interfering matter, re-check the cylinder sensor
position, replace the cylinder sensor with a new one, or
check the air pressure.
Check for interfering matter, re-check the cylinder sensor
position, replace the cylinder sensor with a new one, or
check the air pressure.
Check for interfering matter, re-check the cylinder sensor
position, replace the cylinder sensor with a new one, or
check the air pressure.
Reset the fault with the "RESET" switch on the indica-
tion box. Then, cancel the temporary stop of the sewing
machine.
Reset the fault with the "RESET" switch on the indica-
tion box. Then, cancel the temporary stop of the sewing
machine
Check the loaded position of the bobbin.
– 15 –
key to select DM as a select-
Corrective measure
/
Publicidad
Capítulos
