Publicidad
130524
#. INSTALLATION
2
1
3
5
4
[Removing the carrier bolt]
Remove carrier bolt 1 which is used to fi x the main
body of the sewing machine.
[Removing the fi xing knob]
Remove fi xing knob 2 of the needle thread heat cut-
ter.
[Installing the eye protection cover]
Be sure to install and use eye protection cover 3 .
[ Installing the thread stand]
1) Assemble the thread stand, and set it in the hole
in the top right corner of the machine table.
2) Tighten locknut 4 to fi x the thread stand.
3) When ceiling wiring is possible, pass the power
cord through spool rest rod 5 .
– 3 –
Publicidad
Capítulos
