Datalogger Function; Configuring The Datalogger Function - Promax PROLINK-4/4C Premium Manual De Instrucciones

USER'S MANUAL. PROLINK-4/4C

4.9.4.4 Datalogger Function

The Datalogger function allows the user to carry out, store and/or print out up to
9801 measurements in a fully automatic way. It may be understood as a measurement
matrix whose columns address the 99 measuring configurations (defined in the 99
memories of the equipment) and whose lines permit to store 99 measurements for
every measuring configuration (conducted in different points of the system or in the
same point on different times).
Before to proceed to take measurements by means of the Datalogger function it
is necessary to store the measuring configuration/s in the memory by using the Store
function (see paragraph 4.12.1).
To select the Datalogger function activate the TV mode functions menu, by
pressing the rotary selector [4] when in the TV operation mode. Then, turn the rotary
selector [4] to the Datalogger field and press it, the DATALOGGER screen will appear
automatically.
As you can see in the previous figure, the main screen of the Datalogger function
has three functions: Config (Configuration), Run and Exit. Below these three functions
is the measurements matrix, three columns and five rows are simultaneously displayed
(in the previous figure the datalogger has three stored measurements, one for each of
the first three memories).
To access the various screen functions or fields press key

4.9.4.4.1 Configuring the Datalogger Function.

The configuration menu of the Datalogger function allows you to choose between
taking and/or printing measurements, programming the PROLINK-4/4C
take measurements at a pre-determined time, defining the time interval between
measurements, erasing all measurements stored in the Datalogger function, and
automatically deactivating all the measurement configurations.
06/2005
Premium
Figure 45.- DATALOGGER screen.
[31] repeatedly.
Premium to
Page 73