Replacing The Battery - Promax PROLINK-4/4C Premium Manual De Instrucciones

6.3 Replacing the Battery

Battery must be replaced whenever the capacity of the fully-charged battery is
noticeably diminished. To change the battery, follow next procedure:
In case of the battery appears to be damaged, you must send the equipment to an
authorised Technical Service without trying to replace it.
Replace the old battery by another CB-044 battery. The battery can be bought in
your habitual PROMAX supplier. Explosion or fire hazard can occur if other battery type
is used.
The battery used can present fire or chemical burn hazard if it is severely mistreat.
Do not disassembly or cremate or heat the battery above 100
circumstances.
Switch off the instrument.
-
Remove the rear holster, if in place.
-
The battery compartment is located in the rear panel of the instrument.
-
Remove the securing screw (A) and washer from the compartment cover as
shown in the previous figure (it shows the battery compartment once the
cover and connector linking the battery to the board have been removed).
Disconnect the battery connector strip from the board, and replace the battery
-
with a new.
Page 116
Figure 76.- Battery compartment.
USER'S MANUAL. PROLINK-4/4C
IMPORTANT REMARK
Premium
CAUTION
°
C under no
06/2005