Printing The Spectrum, The Measurements And Memories - Promax PROLINK-4/4C Premium Manual De Instrucciones

USER'S MANUAL. PROLINK-4/4C

4.14 Printing the Spectrum, the Measurements and Memories

By connecting the instrument to a serial printer it is possible to obtain the
spectrum showed on screen or a printed report of a sequence of measurements just at
the moment they are taken, or later, if they are recorded with the Datalogger function.
This enables the user to keep a file about the state of the system and provide the
documents related to the level measurements for analysis purposes. The CI-23 portable
printer is a PROLINK-4/4C
The installation process consists of simply using the data transfer cable to
connect the printer to the RS-232C connector [37] on the PROLINK-4/4C
(see section '4.14.1 Handshake and control lines'). Switch off the power to both
instruments before connecting.
To print the spectrum showed select the function Print on the function menu in
the Spectrum Analyser mode.
To print measurements select the Datalogger function on the functions menu
(see section '4.9.4.4 Datalogger function'), access the configuration menu, activate the
print field (Print : On) and switch on the printer. From now on the printing process is
equivalent to taking measurements. The following figure shows an example of printing
two activated columns (memories 1 and 2) and two activated rows (test points 1 and 2).
06/2005
Premium
Premium optional accessory.
Premium
Page 105