Promax PROLINK-4/4C Premium Manual De Instrucciones página 211

USER'S MANUAL. PROLINK-4/4C
You can make as many acquisitions as there are activated rows in the
measurement matrix (if only one row has been activated, then only one measurement
will be taken).
In the case where the Datalogger function has been programmed to take more
than one measurement in the time domain, i.e. more than one row has been activated
and the acquisition interval is greater than four minutes, then every time an acquisition
is made the instrument will reprogram the alarm for the next measurement. Then it will
switch itself on three minutes before the time defined in the Measure Interval field in
order to warm up and ensure the highest accuracy.
3.- STARTING ACQUISITION (PROGRAMMING THE ALARM)
To program the instrument to take measurements and/or print-outs at a specific
time, you must define the time and date the measurements are to be taken (Start
acquisition time). If this field is not defined the acquisition of measurements will have
to be activated manually (see section '4.9.4.4.3 Taking Measurements'). When
programming the alarm be sure to have checked that the date and time have been
correctly defined beforehand (Clock function, paragraph 4.9.4.5) and to have selected
previously one measurement to be taken at minimum (see section '4.9.4.4.2 Selecting
the Measurement to be Taken').
To define the starting time of measurement acquisition repeatedly press key
[31] until the Start acquisition time field blinks, then press the rotary selector [4]. This
will lead to a screen like the one shown below:
Figure 47.- Defining the starting time of measurement acquisition.
The first line of this screen tells you if the alarm function is on (ALARM On) or not
(ALARM Off), followed by the date and time the alarm has been set for, and the last
line shows the current time and date.
06/2005
Premium
3
Page 75