Presetting The Rds Stations With The Af And Ta Data - Sony MDX-C800REC Manual De Instrucciones

Notes
• "NO TP" flashes for 5 seconds if the received
station does not broadcast traffic
announcements. Then, the unit starts searching
for a station that broadcasts it.
• If you want to change the on/off setting while
you are playing a CD or an MD, press (6) (TA)
directly without pressing (SHIFT).
To cancel the current traffic
announcement
Press (6) (TA).
To cancel all traffic announcements, press
(SHIFT), and turn off the function by
pressing (6) (TA) until "TA off" appears.
Press (SHIFT) to return to normal mode.
Tip
You can also cancel the current announcement by
pressing (SOURCE) or (MODE).
Presetting the volume of traffic
announcements
You can preset the volume level of the traffic
announcements beforehand so you won't miss
the announcement. When a traffic
announcement starts, the volume will be
automatically adjusted to the preset level.
1
Press (SHIFT).
2
Press (6) (TA) for 2 seconds.
"TA" appears and the setting is stored.
3
Turn the volume control dial to adjust
the desired volume level.
4
Press (SHIFT).
Receiving emergency
announcements
If an emergency announcement comes in while
you are listening to the radio, the programme
will be automatically switched to it ("AF"
flashes while receiving the announcement). If
you are listening to a source other than the
radio, the emergency announcements will be
heard if you turn the AF or TA function on.
The unit will then automatically switch to
these announcements no matter which source
you are listening to at the time.
Presetting the RDS
stations with the AF and
TA data
When you preset RDS stations, the unit stores
each station's data as well as its frequency, so
you don't have to turn on the AF or TA
function every time you tune in the preset
station. You can select a different setting (AF,
TA, or both) for individual preset stations, or
the same setting for all preset stations.
Presetting the same setting for all
preset stations
1
Select an FM band (page 29).
2
Press (SHIFT).
3
Press (5) (AF) and/or (6) (TA) to select
"AF on" and/or "TA on."
Note that selecting "AF off" or "TA off"
stores not only RDS stations, but also
non-RDS stations.
4
Press (SHIFT).
5
Press (MENU), then press either side of
(DISC/PRST) repeatedly until "BTM"
appears.
6
Press the (+) side of (SEEK/AMS) until
"BTM" flashes.
7
Press (ENTER).
33