Denon AVR-3802 Instrucciones De Operación página 10

NOTES:
• The omscreen display signals are not output from the color difference {component) video signal
(MONITOR OUT) jacks
• The on-screen display signals are output with priority to the S-VIDEO MONITOR OUT iack during playback
of a video component For example, if the TV monitor is connected to both the AVR-BBO2's S-Video and
video monitor output jacks and signals are input to the AVR-3802 from a video source {VDI_ etc) connected
to both the B-Video and video input jacksr the on-screen display signals are output with priority to the S-
Video monitor output If you wish to output the signals to the video monitor output jack, do not connect a
cord to the S-ViDEO MONITOR OUT iack (For detaib, see page 16}
• The AVR-BBO2's on-screen d splay function is designed for use with high resolut on monitor TVs, so it may
be d fficult to read small characters on TVs with smafl screens or low resolutions
• The setup menu is not displayed when "HEADPHONE ONLY" is selected
I:FJt;Tt__iLr*3 _JFJ;TI
• Speaker system layout
Basic system layout
• The following is an example of the basic layout for a system consisting of eight speaker systems and a
television monitor:
);_ )[,:LT*','.] il_.l iil ,'1II _ iTlllfJ_ i
Subwoofer
f
Front speaker systems
Set these at the sides of the TV or
screen with their front surfaces as flush
with the front of the screen as possible
_peaker system
peaker systems
Surround speaker systems
With the AVR-3802 it is also possible to use the surround speaker selector function to choose the best layout for
a variety of sources and surround modes
• Surround speaker selector function
This function makes it possible to achieve the optimum sound fields for different sources by switching
between two systems of surround speakers (A and B)
i i
L___J L___J
L---J
SB:SURROUNDBACKSPEAKER
Using A only Using B only
I
2
Check that all the connections are correctr then turn on the main unit's power
Display the System Setup Menu _ syetem Setup Menu
_Power Amp Assilnment
1
Speeker Conflluratlon
SB CHAuto FlaK Detect
Delay Time
Channel Level
DIKItel In Aaal=nment
Multi VoL Level
On Screen Display
Auto Tuner Presets
Make this setting to switch the power amplifier for the surround back channel to Multi
At the System Setup Menu, select "Power Amp _ System Setup Menu
Assignment" and press the ENTER button _Power Amp Aealsnment
1
Speaker Coflflluratlen
58 CH Auto Flei Detect
Delay Time
Channel Level
Oliltal In AeslBnmont
Multi Vol, Level
On Screen Display
Auto Tuner Presets
2
Select "Surround Back" to use
as the surround back channel,
"Multi" to use as multi zone
out
Power Amp Assignment
4krrDuedBlCk : _ )
When "Pvlulti _ _sselected
Enter tie setting
The Syste ¥_Setup Menu reappears
• The composition of the signals output from the different channels and the frequency response are adjusted
automatically according to the combination of speakers actually being used
At the System Setup Menu select "Speaker Configuration" syatem Setup Menu
Power Amp Assllnment
1
_Spelker Confiluration
SB CH AULOFlal Detect
Oeley Time
Channel Level
Olzltal In Aasllnment
Multi VoL Level
On Screen Display
Auto Tuner Presets
10