Saw Blade With Additional Cutter - Orbitalum GF 4 AVM Traducción Del Manual De Instrucciones Original

GF 4, GF 6, RA 8, RA 12 (AVM/MVM)
3. Use the handle to turn the motor upwards for about 30° (clockwise) until the saw blade is in cutting position.
4. Turn the star knob (1) until the toothing of the saw blade (3) protrudes into the pipe inside (2). The height of the toothing that
has to project into the pipe inside corresponds to about 1 tooth height (differs depending on the saw blade).
5. If desired, perform a test cut (cutting the pipe, see chap. 9.1.3, p. 90 for machines with AVM, chap. 9.2.2, page 92 for
machines with MVM and chap. 9.3.2, page 95 for working without AVM/MVM), check the cut result and readjust the hand
wheel (1) if necessary.
6. Turn the motor back to its home position.
When working with the AVM: Hold down the STOP button (6), and pivot the motor back into the normal position.
30°
nOTe!
8.6.2

Saw blade with additional cutter

1. Turn the slide with the saw blade and additional cutter (2) all the way down using the hand wheel (1).
2. Insert the pipe so that it almost reaches the additional cutter (2) and tighten using the multifunctional wrench (4).
[REV. 20190510] OC_GF_RA_BA_790142765_00__INH-02_EN
2
1
2
Scale of the hand wheel: a readjustment by one graduation mark results in a radial feed or
bevel alteration of 0.1 mm (0.004"), for the GF 6 of 0.2 mm (0.008").
1
Set-up and assembly
6
1 tooth
height
3
4
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
enGLISH
2
83