Set-Up And Assembly; Mounting The Pipe Cutter On The Workbench; Mounting The Quick-Mounting Plate On The Workbench; Mounting The Pipe Cutter On The Quick-Mounting Plate - Orbitalum GF 4 AVM Traducción Del Manual De Instrucciones Original

GF 4, GF 6, RA 8, RA 12 (AVM/MVM)
8.

SeT-UP AnD ASSeMBLy

nOTe!
8.1

Mounting the pipe cutter on the workbench

Mount the pipe cutter together with the vice, either:
• on the quick-mounting plate (see chap. 8.1.1 for assembly), or
• on the quick-mounting plate with screw clamps (plate is clamped directly to the workbench without pre-drilling).
WARnInG!
8.1.1

Mounting the quick-mounting plate on the workbench

8.1.2

Mounting the pipe cutter on the quick-mounting plate

[REV. 20190510] OC_GF_RA_BA_790142765_00__INH-02_EN
The steps described in chap. 8 are the same for all GF and RA versions.
The pipe cutters are top-heavy and can cause a workbench that is not
load-bearing and not secure against tilting to tilt!
Irreversible crushing and material damage.
X Mount pipe cutters only on stable, load-bearing and non-tilting workbenches.
1. Center-punch screw holes on a stable, load-bearing and
2. Drill Ø 13 mm holes.
3. Fasten the quick-mounting plate with the supplied screws
1. Only insert the pipe cutter in the assembled quickmounting
2. Bolt the pipe cutter securely in place with the hexagon bolt.
Set-up and assembly
non-tilting workbench.
Use the quick-mounting plate as a template.
M12x70 (8.8).
plate on the side with the help of a crane or a similar lifting
tool.
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
enGLISH
77