Cutting The Pipe With Mvm And Beveling It Simultaneously - Orbitalum GF 4 AVM Traducción Del Manual De Instrucciones Original

enGLISH
Operation
nOTe!
9.2.4

cutting the pipe with MVM and beveling it simultaneously

• Pipes with a wall thickness of up to 7 mm (0.276") can be simultaneously cut and beveled.
• If using an additional cutter, the cutter motor has to be turned around the pipe more slowly than during normal cutting, as
two tools are being used at the same time. The procedure is the same as described in chap. 9.2.2, page 92.
nOTe!
94
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
For continuous operation: after beveling, loosen the hexagon nut on the bevel cutter to avoid
damage caused by tension.
7. Switch pipe cutter on.
1 8. Carefully turn the hand wheel (1) of the MVM clockwise
9. Continue turning steadily until the pipe has been beveled
10. Switch off the machine and wait until the machine/tool
• If necessary, lubricate the saw blade and the additional cutter again during work.
• For continuous operation: After cutting loosen the hexagon nut on the saw blade to
avoid damage caused by tension.
• The evenness of the bevel height depends on the roundness of the pipe.
GF 4, GF 6, RA 8, RA 12 (AVM/MVM)
until the pipe wall has been pierced through.
completely.
stops running.
[REV. 20190510] OC_GF_RA_BA_790142765_00__INH-02_EN