Line Laser; Checking The Oil Level Of The Gear And Topping Up; Cleaning The Slide Guide - Orbitalum GF 4 AVM Traducción Del Manual De Instrucciones Original

GF 4, GF 6, RA 8, RA 12 (AVM/MVM)
10.1.1

Line laser

X Own maintenance work on the laser is not permitted. The laser is to be returned to the factory for any maintenance or repair
work that may be required.
X It is not allowed to open, modify or to remove protective covers or housings except for battery change.
10.2

checking the oil level of the gear and topping up

10.3

cleaning the slide guide

WARnInG!
1. Remove the safety screw (1).
2. Turn the slide housing upwards by 180°.
3. Turn the hand wheel (2) counterclockwise.
4. Pull out the slide (3) with the motor upwards.
5. Clean the guides of the slide housing and slide. Lightly lubricate both parts using HD 30 engine oil.
6. Remount the slide. Insert and tighten the safety screw (1).
Position of the safety screw for the GF 4 and GF 6 (AVM/MVM).
[REV. 20190510] OC_GF_RA_BA_790142765_00__INH-02_EN
Servicing, maintenance, troubleshooting
The gears of the pipe cutters have an oil level indicator.
The oil level should be visible in the middle of the inspection
glass.
1. Check the oil level through the inspection glass (2) and top
2. To top up: Unscrew the oil filler screw (1). Fill with special
3. Re-insert and tighten the oil filler screw.
Danger of being injured by a not sufficiently secured slide!
X never dismount the slide by pulling it downwards.
X Always tighten the safety screw when assembling the slide.
1
Position of the safety screw for the RA 8, RA 12 (AVM/MVM).
up if necessary.
Orbitalum Tools gear oil.
1
180°
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
enGLISH
3
2
99