Cutting The Pipe With Avm; Beveling The Pipe With Avm - Orbitalum GF 4 AVM Traducción Del Manual De Instrucciones Original

enGLISH
Operation
9.1.3

cutting the pipe with AVM

IMPORTAnT!
1. Adjust the pipe dimension (see chap. 8.6, p. 82).
2. Adjust the saw blade to the pipe dimension (see chap. 8.6, p. 82).
3. If necessary, tighten the hexagon nut of the saw blade fixture a fraction (see from chap. 8.5, page 80).
4. Adjust the spindle speed and the feed force level (for standard values, see from chap. 8.7.1, page 85).
5. Push the pipe through the vice up to the desired length and clamp it securely.
Pipes whose length exceeds 1 m must be supported with a pipe feeder (see chap. 8.1.3, p. 78).
IMPORTAnT!
6. Apply saw blade lubricant to the saw blade.
Recommendation:
• up to 2": at least every 3 cuts,
• over 2" and with chrome and high-quality steel pipes: prior to every cut.
nOTe!
nOTe!
7. Switch pipe cutter on.
8. Press the START button.
This starts the pipe processing. The cutter automatically shuts off after the complete cut has been made.
9.1.4

Beveling the pipe with AVM

IMPORTAnT!
1. Adjust the pipe dimension (see chap. 8.6, p. 82).
2. Adjust the bevel cutter to the pipe dimension (see chap. 8.6, p. 82).
3. If necessary, tighten the hexagon nut of the bevel cutter fixture a fraction (see from chap. 8.5, page 80).
4. Adjust the spindle speed and the feed force level (for standard values, see from chap. 8.7.1, page 85).
5. Push the pipe through the vice up to the desired length and clamp it securely.
Pipes whose length exceeds 1 m must be supported with a pipe feeder (see chap. 8.1.3, p. 78).
90
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
If the pipe cutter was out of operation for a relatively long time:
X Swivel the cutter motor by 180°.
X Switch on the AVM and the pipe cutter (see chap. 9.1.2, p. 89), let the cutter motor run for
about 10 seconds.
This relubricates all gear components.
Pull off the multifunctional wrench from the spindle before the slide housing starts rotating.
Use only saw blade lubricant (no oils) from Orbitalum Tools (e.g. GF LUB or GF TOP).
Keep the machine clean. Always remove residue from lubricant from the machine.
For continuous operation: After cutting loosen the hexagon nut on the saw blade to avoid
damage caused by tension.
If the pipe cutter was out of operation for a relatively long time:
X Swivel the cutter motor by 180°.
X Switch on the AVM and the pipe cutter (see chap. 9.1.2, p. 89), let the cutter motor run
for about 10 seconds.
This relubricates all gear components.
GF 4, GF 6, RA 8, RA 12 (AVM/MVM)
[REV. 20190510] OC_GF_RA_BA_790142765_00__INH-02_EN