Cutting And Beveling Pipes Simultaneously - Orbitalum GF 4 AVM Traducción Del Manual De Instrucciones Original

GF 4, GF 6, RA 8, RA 12 (AVM/MVM)
IMPORTAnT!
6. Apply saw blade lubricant to the bevel cutter:
Recommendation:
• up to 2": at least every 3 cuts,
• over 2" and with chrome and high-quality steel pipes: prior to every cut.
nOTe!
nOTe!
7. Switch pipe cutter on.
8. Press the START button.
This starts the pipe processing. The cutter automatically shuts off after the correct bevel has been cut.
9.1.5

cutting and beveling pipes simultaneously

• Pipes with a wall thickness of up to 7 mm (0.276") can be simultaneously cut and beveled.
• • If using an additional cutter, the cutter motor has to be turned around the pipe more slowly than during normal cutting,
• as two tools are being used at the same time. The procedure is the same as described in chap. 9.1.3, page 90.
nOTe!
[REV. 20190510] OC_GF_RA_BA_790142765_00__INH-02_EN
Pull off the multifunctional wrench from the spindle before the slide housing starts rotating.
Use only saw blade lubricant (no oils) from Orbitalum Tools (e.g. GF LUB or GF TOP).
Keep the machine clean. Always remove residue from lubricant from the machine.
For continuous operation: After beveling, loosen the hexagon nut on the bevel cutter to avoid
damage caused by tension.
• If necessary, lubricate the saw blade and the additional cutter again during work.
• For continuous operation: After cutting, loosen the hexagon nut on the saw blade to
avoid damage caused by tension.
• The evenness of the bevel height depends on the roundness of the pipe.
Operation
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
enGLISH
91