Opening The Enclosures; Panel-Mount Enclosure; Harsh Enclosure - Mettler Toledo IND560 Guia De Instalacion

IND560 Installation Manual

Opening the Enclosures

Procedures for opening the IND560 terminal panel-mount and harsh enclosures
differ and are described in the following sections.

Panel-Mount Enclosure

The panel-mount version of the IND560 is opened by removing the three
Phillips-head screws on the back panel (see Figure 2-1). The rear panel can then
be removed to gain access to the internal workings of the terminal.

Harsh Enclosure

The front panel of the harsh enclosure IND560 terminal is locked in place by four
spring clips attached to the enclosure body. To gain access to the terminal's PCB
for internal wiring and setting switches, separate the front panel from the enclosure
as follows:
1. Insert the tip of a flat-blade screwdriver into one of the two slots located on the
bottom of the front panel assembly (see Figure 2-2)and gently push in toward
the enclosure. A "pop" sound is made when the cover is released.
2-2
Figure 2-1: Opening the Panel-Mount Enclosure